María Pérez Muñoz

This week We have Removal/Installation of the EDP (Engine Drive Pumps) The EDP serve as the primary hydraulic flow and pressure supply for the hydraulic users within the aircraft system. It should be noted, that the EDP does not supply hydraulic flow at the same speed at with the propeller moves, the EDP has control valves that control the hydraulic flow. For removal there has been no problem, however, for installation, someone moved the propoller, and how the EDP ir geared to the engine, we had a little difficulty in introducing the EDP, but it was resolved quickly by moving the propoller a little, making the EDP fit into the gears. This is the EDP (Engine Drive Pumps): My personal week..... This week I have had many difficult exams, but the truth... I haven't studied because for personal problems...In addition my dear cat 😻, as usual, doesn't let me study in peace, she always put on top of my manuals and when I tell her to go away, she answers:  This weekend I changed the sp

  This week we practiced the hydraulic reservoir REMOVAL/INSTALLATION of the Turbocommander 680V. To do this I had to get into a very small compartment, and since I am the smallest, as always, almost all the work was done by me, although I don't mind, I really like mechanics and I love being busy.  There was a mosquito that bit me 30 times on my arms (💥*30), so my patience was reduced even more than the space I had to work  This is de Hydraulic Reservoir:  The  hydraulic reservoir  is a container for holding the hydraulic fluid required to supply the system, normally the most common hydraulic is called Skydrol, this fluid es very danger 💀 so  special care must be taken, use the corresponding EPIS.  An instructor advised us to have milk 🐄 because if the hydraulic fluid falls into the eyes 👀, it is very painful and milk calms the pain  Well... You know my tour from Globalia to My house 😵 And my crossfit training from monday to friday ..... If you want I can make a vídeo for you

In Globalia: We are giving theoretical and practical classes on aircraft systems, more specifically ATA29 Hydraulic Systems A hydraulic system uses a fluid under pressure to drive machinery or move mechanical components. All aircraft make use of some hydraulically powered components. In light, general aviation aircraft, this use might be limited to providing pressure to activate the wheel brakes. In larger and more complex aeroplanes, the use of hydraulically powered components is much more common. Depending upon the aircraft concerned, a single hydraulic system, or two or more hydraulic systems working together, might be used to power any or all of the following components: wheel brakes nose wheel steering landing gear flaps and slats thrust reversers spoilers/speed brakes flight control surfaces etc Hydraulic system consists of the hydraulic fluid plus three major mechanical components. Those components are the “pressure generator” or hydraulic pump, the hydraulically powered “moto

 To get to Globalia Formación, take the Ma-19 towards Llucmajor. The exit is number 22 towards the Son Noguera industrial estate. As soon as you arrive at the polygon, you will quickly find Globalia, the first large building on the right. You can park outside freely or inside as a visitor if you are not registered at the security control. You are the red spot,  Directions to the general building: Directions to the training building where the students are: When you enter the building, you must wear your mask and clean your hands with hydroalcoholic gel, there are dispensers all over the building. You must climb the stairs and go to class number 12. I hope that with these directions you can reach Globalia without problems, otherwise you can click on this link and the Google Maps GPS will indicate you perfectly. Indications Google Maps